Android Phone Not Charging? 10 Fixes to Try in Order
Start with the free checks (cable, brick, port, charge limits) and work up to hardware. Samsung and Pixel settings paths included.


AndroidCare Editorial · Updated · 6 min read
On this page
- 1. Swap one thing at a time: outlet, charger, cable
- 2. Clean the charging port (carefully)
- 3. Clear a "Moisture detected" warning (Samsung)
- 4. Restart the phone
- 5. Check whether a charge limit is stopping at 80%
- 6. Let the phone cool down (or warm up)
- 7. Check the fast-charging switches
- 8. If wireless charging is the problem
- 9. Check battery health
- 10. When it's hardware: the port or the battery
- Quick checklist
- Sources
When an Android phone stops charging, the cause is usually one of three things: the cable or charger, a dirty charging port, or a setting that stops charging on purpose. A real battery or port failure is less common than it feels at the time, so it makes sense to rule out the cheap causes first.
The fixes below are in the order we suggest trying them. Where Samsung Galaxy (One UI) and Google Pixel differ, both paths are listed. Menu names change between software versions, so if a label doesn't match, search Settings for the nearest equivalent.
Stop first if: the phone is swollen, the screen is lifting at an edge, there's a burning smell, or the phone gets very hot while plugged in. Unplug it, don't charge it again, and go straight to the hardware section at the end.
1. Swap one thing at a time: outlet, charger, cable
Charging has four parts: the outlet, the charger (the "brick"), the cable and the phone. Change one at a time so you know which part is at fault.
- Plug the charger into a different wall outlet. Skip power strips and laptop USB ports for this test.
- Try a different cable. Cables fail far more often than chargers, usually near the connector where they bend.
- Try a different charger, ideally the one that came with a recent phone or a known-good USB-C charger.
- If you can, charge a different device with your cable and brick.
If the phone charges with a different cable, you've found the problem. Throw the bad cable out rather than keeping it as a spare.
2. Clean the charging port (carefully)
Pocket lint packs into USB-C ports over months. The plug then can't seat fully, so the phone charges only at certain angles, charges slowly or doesn't charge at all. Shine a flashlight into the port. A grey felt-like layer at the back is the classic sign.
To clean it:
- Power the phone off.
- Use a wooden or plastic toothpick, or a dry soft brush. Never use metal (pins, paper clips, needles). They can short or bend the contacts.
- Gently scrape along the inside walls and the back of the port, not the thin center tongue.
- Finish with a short puff of compressed air, holding the can upright.
A plug that clicks in firmly afterward is a good sign. If the port still feels loose, it may be worn, which is a hardware repair.
3. Clear a "Moisture detected" warning (Samsung)
Water-resistant Galaxy phones check the USB-C port for moisture and block wired charging until it's dry. You'll see a "Moisture detected" or similar message and a water-drop icon.
- Unplug the cable and wait until the phone and the cable connector are fully dry, which can take a few hours.
- Gently tap the phone, port facing down, to shake out water.
- Don't use a hair dryer, oven or rice. Heat can damage the phone and rice leaves dust in the port.
- Wireless charging still works while the port is wet, if your phone supports it.
If the warning keeps appearing when the phone has not been near water, restart it, clean the port as in step 2, and try another cable. A warning that won't go away on a dry phone can point to port corrosion.
4. Restart the phone
A restart clears stuck software and costs nothing. Hold the side (power) button, or the side and volume-down buttons on recent Galaxy phones, then choose Restart. Plug in again once it boots.
5. Check whether a charge limit is stopping at 80%
If the phone charges but "stops" at 80%, 85% or 95%, a battery-protection setting is probably doing its job. Both brands offer one.
Samsung (One UI 7 and later): Settings > Battery > Battery protection. You'll see three modes:
- Basic: charges to 100%, then stops and resumes at 95%.
- Adaptive: holds at 80% while you're asleep and finishes before you usually wake up.
- Maximum: stops at a ceiling you choose (on One UI 7 you can pick 80%, 85%, 90% or 95%).
On older One UI versions it was a single Protect battery switch under Settings > Battery and device care > Battery (sometimes inside More battery settings).
Pixel: Settings > Battery > Battery health > Charging optimization. Adaptive Charging finishes to 100% just before you usually unplug; Limit to 80% (Pixel 6a and later) holds at 80%.
These settings are good for the battery's lifespan. Turn them off only if you need a full charge today.
6. Let the phone cool down (or warm up)
Lithium-ion batteries charge safely only within a temperature range. If the phone is hot after gaming, sitting in a car or charging under a pillow, Android slows or pauses charging until it cools. Samsung's support pages note that charging can be limited automatically when the temperature rises. The same is true in a freezing car.
Take the phone out of its case, put it on a hard surface out of direct sun and let it cool. Don't put it in the fridge or freezer; fast temperature swings can cause condensation inside. Our overheating guide has more.
7. Check the fast-charging switches
If the phone charges, but slowly, check that fast charging is turned on.
- Samsung: Settings > Battery > Charging settings, then turn on Fast charging (and Fast wireless charging if you use a pad). On older One UI versions look under Settings > Battery and device care > Battery > More battery settings.
- Pixel: there is no fast-charging switch. Pixels fast charge automatically when the charger supports USB Power Delivery with PPS.
Even with the switch on, you only get the top speed if the charger supports what the phone needs. A 5W cube from an old phone will charge a current flagship very slowly. Our guide to choosing a USB-C charger explains the specs.
8. If wireless charging is the problem
Wireless pads need alignment and very little in between.
- Remove thick cases, phone grips, metal plates and wallet cases holding cards. Samsung's support guidance warns that metal, magnets or cards between the phone and charger can cause heating.
- Center the phone on the pad. The coil sits around the middle of the back on most phones.
- Check the pad's own power adapter. Many pads ship without one, and a weak adapter means slow charging.
If wired charging works but wireless doesn't, the pad or its adapter is the likely culprit, not the phone.
9. Check battery health
An old battery holds less charge and can drop suddenly from 20% to 0%, which can look like a charging problem.
- Samsung: open the Samsung Members app, go to Support > Phone diagnostics and run Battery status. It reports the battery's condition.
- Pixel: Settings > Battery > Battery health shows capacity and status on recent models (Pixel 8a and later).
If the battery is rated weak or well below its original capacity, a battery replacement is usually much cheaper than a new phone. While you're in Settings, install any pending software update too (Samsung: Settings > Software update; Pixel: Settings > System > Software updates), since updates sometimes fix charging bugs.
10. When it's hardware: the port or the battery
If you've tried a known-good cable and charger, cleaned the port and checked the settings, and the phone still won't charge, it's probably hardware.
- Worn or damaged USB-C port: the plug wobbles, only works at an angle, or the phone shows charging on and off.
- Failing battery: drains fast, shuts down at 20–30%, or won't take a charge at all.
- Water damage: a phone that was submerged may need a professional inspection even if it seems fine.
- Swelling: a lifted screen, gaps around the frame or a rocking phone on a flat table. Stop using and charging it right away. A swollen lithium-ion battery is a fire risk.
For repairs, start with the manufacturer's support site, since your phone may still be under warranty. If you use an independent shop, ask what parts they use and whether the repair comes with a warranty.
Quick checklist
| Symptom | Most likely cause | Try first |
|---|---|---|
| Charges only at an angle | Lint in port / worn port | Step 2 |
| "Moisture detected" (Samsung) | Wet or dirty port | Step 3 |
| Stops at 80–95% | Battery protection / charge limit | Step 5 |
| Charges very slowly | Weak brick, old cable, fast charging off | Steps 1, 7 |
| Pauses when hot | Temperature protection | Step 6 |
| Nothing with any cable | Port or battery hardware | Steps 9–10 |
Sources
- Samsung US: Charge your Galaxy Z Fold7, Z Flip7, or Z Flip7 FE (charging settings and cable guidance)
- Google: Get the most life from your Pixel phone battery (Battery health, Charging optimization)
- Samsung: Why is your Samsung Galaxy device heating up (charging limitation during temperature rise)
Related guides

How to Free Up Storage on Android Without Losing Photos
Empty the trash folders, clear caches and remove downloads first. Then move backed-up photos off the phone, in that order.

Android Phone Overheating? Causes and Safe Ways to Cool It
Warm is normal during charging, gaming and navigation. Here is how to cool a hot phone safely, find the cause and spot a real fault.

Android Battery Draining Fast? 9 Settings to Check
Find out what is using the power first, then fix the screen, background apps and signal settings that cause most battery drain.